6V/12V 10A battery charger with LCD
Our products are exported to North America, Australia, the Middle East, Africa, Southeast Asia, South America, and Europe.
|STEP 0 Battery activated: ||After the selection of the charging mode , the charger check the status of the battery .If the Voltage lower than 5V ,will use trickle charging to activate the battery. |
|STEP 2 Battery Repair: ||After the selection of the charging mode , the charger check the status of the battery .For old batteries or batteries that have not been used for a long time, it will charge with pulse current to expand the battery capacity again. |
|STEP 3 Pulse current charge: ||Save the battery with impulse charging prepare for Bulk charging . |
|STEP 4 Constant Current charging: ||Charging with maximum current until approximately 80% battery capacity. |
|STEP 5 Constant Voltage charging: ||Charging with steady charging voltage to maximize up to 100% battery capacity. |
|STEP 6 Floating Charge: ||Charge optimization / Charge with small Constant current charging |
|STEP 7 Flat Charge: ||Charge optimization / Charge with smaller Constant current charging to maximize the battery charge, try to reach a fully charged state. |
|STEP 8 Analysis Battery ; ||Stop 1 minutes, Analysis the charging voltage, to determine whether is full. |
|STEP 9 Compensation Charge: ||Battery capacity will be kept at 95-100% and the battery voltage will be supervised. if necessary the charger will give an implulse to the battery to keep it completely recharged. |
We are positive to enlarge our markets in other countries.
welcome your inquiry!